Welcome, Guest
Username: Password: Remember me

TOPIC: Cannot get [Replace by / Bind to] working

Cannot get [Replace by / Bind to] working 1 month 1 week ago #1

  • Rob Vousten
  • Rob Vousten's Avatar
  • Offline
  • New Member
  • Posts: 2
I'm new and ignorant, so I hope you can help. I want to replace some rarely used sounds (gunshot, telephone, etc.) by drum sounds (kick, snare, etc.) so I can have seperate tracks for those. I managed to replace gunshot with telephone but replacing it with a kick or snare does not work. Only silence... Is it possible or should I give up?
Last Edit: 1 month 1 week ago by Rob Vousten.
The administrator has disabled public write access.

Cannot get [Replace by / Bind to] working 1 month 1 week ago #2

  • ziyametedemircan
  • ziyametedemircan's Avatar
  • Offline
  • Elite Member
  • Posts: 168
  • Thank you received: 55
If you set the Root-Key and Key-range properly, it's fine.
For Key range: 0-127 is suitable.
The root key may vary, but it is usually set to 60 (middle C) on non pitched percussion instruments.
Last Edit: 1 month 1 week ago by ziyametedemircan.
The administrator has disabled public write access.
The following user(s) said Thank You: Rob Vousten

Cannot get [Replace by / Bind to] working 1 month 1 week ago #3

  • Rob Vousten
  • Rob Vousten's Avatar
  • Offline
  • New Member
  • Posts: 2
Thanks! Setting key range to [0-127] on all occasions did the trick.
The administrator has disabled public write access.
Time to create page: 0.057 seconds
Cron Job Starts